Dialer Bundle-Member - H3C MSR Series Command Reference Manual

Syntax
dialer bundle enable
undo dialer bundle enable
Default
No DDR is enabled on a dialer interface.
Views
Dialer interface view
Predefined user roles
network-admin
Usage guidelines
DDR includes C-DDR and B-DDR.
Before using B-DDR, you must use this command to enable B-DDR on a dialer interface and then assign
physical interfaces to the corresponding dialer bundle by using the dialer bundle-member command. To
enable B-DDR to receive incoming calls, configure the dialer peer-name command on the dialer
interface.
If you configure this command on a dialer interface already enabled with B-DDR, the system clears the
original B-DDR dialup configuration.
The undo dialer bundle enable command clears all DDR configurations on a dialer interface.
Examples
# Enable B-DDR on interface Dialer 1.
<Sysname> system-view
[Sysname] interface dialer 1
[Sysname-Dialer1] dialer bundle enable
Related commands
•

dialer bundle-member

dialer circular enable
•
• dialer peer-name
dialer bundle-member
Use dialer bundle-member to assign a physical interface to a dialer bundle in B-DDR.
Use undo dialer bundle-member to remove a physical interface from a dialer bundle.
Syntax
dialer bundle-member number [ priority priority ]
undo dialer bundle-member number
Default
A physical interface does not belong to any dialer bundle.
Views
Physical interface view
135