Isdn Overlap-Sending; Isdn Pri-Slipwnd-Size - H3C MSR Series Command Reference Manual

[Sysname] interface bri 2/0
[Sysname-Bri2/0] isdn number-property 0 called out

isdn overlap-sending

Use isdn overlap-sending to set the system to send the called number in overlap mode on an ISDN
interface.
Use undo isdn overlap-sending to restore the default.
Syntax
isdn overlap-sending [ digits ]
undo isdn overlap-sending
Default
The "en bloc" mode applies.
Views
ISDN interface view
Predefined user roles
network-admin
Parameters
digits: Specifies the maximum number of digits that can be sent each time in overlap mode, in the range
of 1 to 15. The default is 10.
Usage guidelines
In overlap mode, the digits of each called number are sent separately and the number of the digits sent
each time can be set through this command.
In "en bloc" mode, all the digits of each called number are sent at a time.
Overlap sending is supported only by the ISDN protocols such as ANSI, DSS1, ETSI, NI, and QSIG.
You can execute this command only if no call exists on an ISDN interface.
Examples
# Set the system to send the called number in overlap mode on interface BRI 2/0 and set the number of
digits allowed to send each time to 12 digits.
<Sysname> system-view
[Sysname] interface bri 2/0
[Sysname-Bri2/0] isdn overlap-sending 12

isdn pri-slipwnd-size

Use isdn pri-slipwnd-size to set the sliding window size of a PRI.
Use undo isdn pri-slipwnd-size to restore the default.
Syntax
isdn pri-slipwnd-size window-size
undo isdn pri-slipwnd-size
89