H3C MSR Series Command Reference Manual page 79

network-operator
Parameters
interface interface-type interface-number: Specifies a BRI that runs the NI protocol by its type and number.
If you do not specify an interface, this command displays SPID information on all the NI-supported BRIs.
Usage guidelines
You can execute this command to display information such as the SPID type and SPID value when ISDN
is running.
Examples
# Display SPID information on NI-supported interface BRI 2/0 (the SPID type is AUTO).
<Sysname> display isdn spid interface bri 2/0
Interface Bri2/0:
SPID Type: AUTO
SPID B1:
SPID Num: 235
Neg State: SPID_UNASSIGNED
Init State: INIT_NULL
SPID B2:
SPID Num: 326
Neg State: SPID_UNASSIGNED
Init State: INIT_NULL
SPID timer: 30 seconds
SPID resend: 1 times
# Display SPID information on NI-supported interface BRI 2/0 (the SPID type is STATIC).
<Sysname> display isdn spid interface bri 2/0
Interface Bri2/0:
SPID Type: STATIC
SPID B1:
SPID Num: 134
LDN: 3251
Init State: INIT_NULL
SPID B2:
SPID Num: 257
LDN: 3657
Init State: INIT_NULL
SPID timer: 30 seconds
SPID resend: 1 times
# Display SPID information on NI-supported interface BRI 2/0 (the SPID type is NIT).
<Sysname> display isdn spid interface bri 2/0
Interface Bri2/0:
SPID Type: NIT
70