Dialer Callback-Center - H3C MSR Series Command Reference Manual

Predefined user roles
network-admin
Parameters
number: Specifies the dialer bundle number, which is the same as the dialer interface number.
priority priority: Specifies the priority of a physical interface in the dialer bundle, in the range of 1 to 255.
The higher the number, the higher the priority. The physical interface with a higher priority is used first.
The default priority is 1.
Usage guidelines
This command applies only to physical interfaces. A physical interface can belong to multiple dialer
bundles.
When the dialer interface does not exist, this command creates one and enables B-DDR on it.
Examples
# Assign interface BRI 1/0 to Dialer bundle 1 and Dialer bundle 2, with a priority of 50 in both.
<Sysname> system-view
[Sysname] interface bri 1/0
[Sysname-Bri1/0] dialer bundle-member 1 priority 50
[Sysname-Bri1/0] dialer bundle-member 2 priority 50
Related commands
dialer bundle enable
•
• interface dialer

dialer callback-center

Use dialer callback-center to configure the PPP callback reference.
Use undo dialer callback-center to remove the setting.
Syntax
dialer callback-center [ user | dial-number ] *
undo dialer callback-center
Default
No PPP callback reference is configured.
Views
Dialup interface (physical or dialer interface) view
Predefined user roles
network-admin
Parameters
user: Sets the callback reference to user mode, in which DDR identifies which dial string is to be used for
placing a return call based on the remote username configured in the dialer route command.
dial-number: Sets the callback reference to dial number mode, in which DDR uses dial strings configured
in authorization-attribute callback-number commands in local user view to place return calls. When
136