Isdn Number-Property - H3C MSR Series Command Reference Manual

Usage guidelines
Timers T302 and T304 are associated with the overlap sending and receiving state, respectively for a
call. If the ISDN network layer protocol does not support overlap sending, the timer configuration for
T302 and T304 is not supported.
The AT&T, NTT, NI2, and 5ESS protocols do not support the timer configuration for T302 and T304.
Examples
# Set the timeout value of L3 timer T301 to 160 seconds on BRI 2/0.
<Sysname> system-view
[Sysname] interface bri 2/0
[Sysname-Bri2/0] isdn l3-timer t301 160
Related commands
display isdn parameters
•
isdn overlap-sending
•

isdn number-property

Use isdn number-property to set the number type and code scheme for calling or called numbers in
incoming or outgoing ISDN calls.
Use undo isdn number-property to restore the default.
Syntax
isdn number-property number-property [ calling | called ] [ in | out ]
undo isdn number-property [ calling | called ] [ in | out ]
Default
The ISDN number type and code scheme (number-property) that the system selects depends on the upper
layer service.
Views
ISDN interface view
Predefined user roles
network-admin
Parameters
number-property: Specifies the type and number scheme of ISDN numbers, a hexadecimal string in the
range of 0 to 7F. It is expressed in 8 bits, in which bits 1 through 4 represent the code scheme, bits 5
through 7 represent the code type, and bit 8 is reserved.
code schemes. For more information, see the related protocol.
Table 15
82
lists the possible number types and