Display Cellular - H3C MSR Series Command Reference Manual

<Sysname> system-view
[Sysname] controller cellular 0/0
[Sysname-Cellular0/0] description Cellular-intf

display cellular

Use display cellular to display the call connection information of a 3G modem.
Syntax
display cellular interface-number
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-number: Specifies a cellular interface by its number.
Usage guidelines
If no cellular interface is specified, call connection information for all 3G modems is displayed.
The command output might vary with modems of different manufacturers.
Examples
# Display the call connection information on Cellular 0/0 (WCDMA network).
<Sysname> display cellular 0/0
Cellular0/0:
Hardware Information:
Model: E176G
Modem Firmware Version: 11.604.09.00.00
Hardware Version: CD25TCPU
International Mobile Subscriber Identity (IMSI): 460029010431055
International Mobile Equipment Identity (IMEI): 353871020138548
Factory Serial Number (FSN):
Modem Status: Online
Profile Information:
Profile 1: Active
PDP Type: IPv4, Header Compression: Off
Data Compression: Off
Access Point Name (APN): 001
Packet Session Status: Inactive
Modem Setup Information:
Diagnostics Monitor: Close
Network Information:
Current Service Status: Service available
Current Service: Combined
Packet Service: Attached
DK9RAA1871500602
109