Dialer Number; Dialer Peer-Name - H3C MSR Series Command Reference Manual

[Sysname] dialer flow-interval 3
Related commands
dialer threshold

dialer number

Use dialer number to configure a dial string for placing calls to a single remote end.
Use undo dialer number to remove the configured dial string.
Syntax
dialer number dial-number [
undo dialer number
Default
No dial string is configured for calling the remote end.
Views
Dialup interface (physical or dialer interface) view
Predefined user roles
network-admin
Parameters
dial-number: Dial string for calling a remote end, a case-insensitive string of 1 to 30 characters.
autodial: Enables the router to automatically dial the configured dial string at certain intervals. The
interval is set in the dialer timer autodial command and defaults to 300 seconds.
Usage guidelines
You must configure this command when the dialer or physical interface is the calling party.
In C-DDR, you can also use the dialer route command to configure multiple destination addresses or dial
strings. However, in B-DDR, you can only use the dialer number command to configure one dial string for
each dialer interface, because associations between dialer interfaces and call destination address are
one-to-one.
Examples
# Set the dial string for placing calls to 1 1 1 1 1 on interface Dialer 1.
<Sysname> system-view
[Sysname] interface dialer 1
[Sysname-Dialer1] dialer number 11111
Related commands
dialer route

dialer peer-name

Use dialer peer-name to configure the remote username in B-DDR for PPP authentication when receiving
calls.
Use undo dialer peer-name to remove the configured remote username.
]
autodial
142