[Sysname-Serial2/1] dialer circular-group 1
Related commands
•
dialer circular enable
dialer priority
•
•
interface dialer
dialer diagnose
Use dialer diagnose to configure DDR to operate in diagnostic mode.
Use undo dialer diagnose to restore the default.
Syntax
dialer diagnose [
undo dialer diagnose
Default
DDR operates in non-diagnostic mode.
Views
Dialer interface view
Predefined user roles
network-admin
Parameters
seconds: Specifies the diagnostic interval in the range of 5 to 65535 seconds. The default is 120
seconds.
Usage guidelines
This command applies only when a dialer interface is used with PPPoE client application.
In diagnostic mode, the device dials a PPPoE connection immediately after the device configurations are
complete, automatically terminates the connection and starts the auto-dial timer after a configurable
diagnostic interval, and redials a connection when the auto-dial timer expires. By establishing and
terminating PPPoE sessions periodically, you can monitor the operating status of the PPPoE link.
In diagnostic mode, the link idle-timeout timer is ignored.
Examples
# Configure interface Dialer 1 to operate in diagnostic mode, with a diagnostic interval of 300 seconds.
<Sysname> system-view
[Sysname] interface dialer 1
[Sysname-Dialer1] dialer diagnose interval 300
Related commands
dialer timer autodial
•
dialer timer idle
•
]
interval seconds
140