Service - H3C MSR Series Command Reference Manual

If you specify the virtual-template keyword without the interface-number argument, this command clears
statistics on all VT interfaces.
If you specify both virtual-template and interface-number, this command clears statistics on the specified
VT interface.
Examples
# Clear statistics on interface Virtual-Template 10.
<Sysname> reset counters interface virtual-template 10
Related commands
display interface virtual-template

service

NOTE:
Only the MSR 5600 routers support this command.
Use service to specify a card to forward the traffic of VA interfaces on a VT interface.
Use undo service to restore the default.
Syntax
service slot slot-number
undo service slot
Default
No card is specified.
Views
VT interface view
Default command level
network-admin
Parameters
slot slot-number: Specifies a card by its slot number.
Usage guidelines
If you do not specify a card to forward the traffic of VA interfaces on a VT interface, the system
automatically chooses the MPU to forward the traffic. Therefore, to reduce the load on the MPU, H3C
recommends that you use this command to specify cards to forward traffic of VA interfaces.
If the specified card is removed, the traffic cannot be forwarded even if a VA interface is up. When the
card is installed, traffic forwarding resumes on the card.
Examples
# Specify the card in slot 2 to forward traffic of the VA interfaces on interface Virtual-Template 10.
<Sysname> system-view
[Sysname] interface virtual-template 10
[Sysname-Virtual-Template10] service slot 2
32