Isdn Spid1 - H3C MSR Series Command Reference Manual

[Sysname] interface bri 2/0
[Sysname-Bri2/0] isdn spid timer 50
Related commands
isdn spid resend

isdn spid1

Use isdn spid1 to configure SPID information for the B1 channel on a BRI that runs the NI protocol.
Use undo isdn spid1 to remove SPID information for the B1 channel on the BRI.
Syntax
isdn spid1 spid [ ldn ]
undo isdn spid1
Default
Both SPID and LDN for the B1 channel on the BRI are null.
Views
ISDN BRI interface view
Predefined user roles
network-admin
Parameters
spid: Sets the SPID, a string of 1 to 20 digits.
ldn: Sets the local dialing number, a string of 1 to 30 digits.
Usage guidelines
On a BRI that runs the NI protocol, calls can be placed only after the SPID negotiation or initialization is
finished. SPID information can be obtained through static configuration or dynamic negotiation. The PBX
determines which method to use.
The device uses dynamic negotiation to obtain a SPID by default.
The SPID and LDN of the PBX are provided by a common carrier. You must configure the same SPID value
and LDN for both the B1 and B2 channels as that of the PBX.
After you configure LDN, the calling number configured in the isdn calling command becomes invalid.
Execute this command only on a BRI that runs the NI protocol.
Execute this command only if no call exists on the BRI.
You cannot execute this command during the SPID negotiation on the BRI.
Examples
# Assign the SPID 012345 and the LDN 54321 to the B1 channel on interface BRI 2/0.
<Sysname> system-view
[Sysname] interface bri 2/0
[Sysname-Bri2/0] isdn spid1 012345 54321
Related commands
isdn calling
•
97