Reset Pppoe-Client; Reset Pppoe-Client Session Packet - H3C MSR Series Command Reference Manual

[Sysname-Virtual-Ethernet0] pppoe-client dial-bundle-number 1
# Establish a PPPoE session on VLAN interface 1.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] pppoe-client dial-bundle-number 1
# Establish a PPPoE session on WLAN Ethernet interface WLAN-Ethernet 1.
<Sysname> system-view
[Sysname] interface wlan-ethernet 1
[Sysname-WLAN-Ethernet1] pppoe-client dial-bundle-number 1

reset pppoe-client

Use reset pppoe-client to reset a PPPoE session corresponding to a dialer bundle.
Syntax
reset pppoe-client { all | dial-bundle-number number }
Views
User view
Predefined user roles
network-admin
Parameters
all: Resets all the PPPoE sessions.
dial-bundle-number number: Specifies a dialer bundle by its number in the range of 0 to 1023.
Usage guidelines
A PPPoE session in permanent mode and terminated by this command will be established again when
the auto dial timer expires.
A PPPoE session in on-demand mode and terminated by this command will be established again only
when there is a need for data transmission.
Examples
# Reset all PPPoE sessions.
<Sysname> reset pppoe-client all
Related commands
dialer timer autodial (DDR commands)

reset pppoe-client session packet

Use reset pppoe-client session packet to reset the protocol packet statistics for a PPPoE session.
Syntax
reset pppoe-client session packet [ dial-bundle-number number ]
Views
User view
37