Dialer Priority - H3C MSR Series Command Reference Manual

Syntax
dialer peer-name username
undo dialer peer-name [ username ]
Default
No remote username is configured.
Views
Dialer interface view
Predefined user roles
network-admin
Parameters
username: Specifies the remote username for PPP authentication, a case-insensitive string of 1 to 80
characters.
Usage guidelines
The device checks the remote username obtained in PPP authentication against the remote usernames
configured by this command to determine which dialer interface receives which call.
This command is effective only on B-DDR dialer interfaces. You can configure a maximum number of 255
remote usernames for a dialer interface. This enables one dialer interface to receive calls from multiple
dialup interfaces.
If a B-DDR dialer interface is not configured with any remote username, this interface can place calls but
cannot receive calls.
Examples
# Set the remote username for interface Dialer 1 to routerb.
<Sysname> system-view
[Sysname] interface dialer 1
[Sysname-Dialer1] dialer peer-name routerb
Related commands
ppp pap local-user (
•
ppp chap user (
•

dialer priority

Use dialer priority to assign a priority to the physical interface in its dialer circular group in C-DDR.
Use undo dialer priority to restore the default.
Syntax
dialer priority priority
undo dialer priority
Default
The priority of a physical interface in its dialer circular group is 1.
Layer 2—WAN Access Command Reference
Layer 2—WAN Access Command Reference
)
143
)