Isdn Spid Auto-Trigger; Isdn Spid Nit - H3C MSR Series Command Reference Manual

# Set ISDN 5ESS to be run on Serial 1/0:23.
<Sysname> system-view
[Sysname] interface serial 1/0:23
[Sysname-Serial1/0:23] isdn protocol-type 5ess
Related commands
isdn protocol-mode

isdn spid auto-trigger

Use isdn spid auto-trigger to trigger SPID autonegotiation once on a BRI that runs the NI protocol.
Syntax
isdn spid auto-trigger
Default
A BRI does not initiate a SPID negotiation request unless triggered by a call.
Views
ISDN BRI interface view
Predefined user roles
network-admin
Usage guidelines
Use this command only on a BRI that runs the NI protocol.
A BRI that runs the NI protocol can initiate a call only after SPID negotiation or initialization. SPID
information can be obtained through static configuration or dynamic negotiation. You can manually
trigger a SPID negotiation request through this command if the dynamic negotiation fails or for the
purpose of testing.
Do not use this command without configuring the SPID negotiation on a BRI.
Execute this command only if no call exists on a BRI.
You cannot execute this command during the dynamic negotiation on a BRI.
Examples
# Trigger a SPID negotiation request on BRI 2/0.
<Sysname> system-view
[Sysname] interface bri 2/0
[Sysname-Bri2/0] isdn spid auto-trigger

isdn spid nit

Use isdn spid nit to set the SPID processing mode to not initial terminal (NIT) on a BRI that runs the NI
protocol.
Use undo isdn spid nit to disable the NIT mode on a BRI.
Syntax
isdn spid nit
93