Isdn Spid Resend - H3C MSR Series Command Reference Manual

undo isdn spid nit
Default
A BRI does not use the NIT mode. The SPID negotiation is used instead.
Views
ISDN BRI interface view
Predefined user roles
network-admin
Usage guidelines
Use this command only on a BRI that runs the NI protocol.
A BRI that runs the NI protocol can initiate a call only after SPID negotiation or initialization. You can
execute this command to set the SPID processing mode to NIT on the device, when it communicates with
a PBX that runs the NI protocol and does not support the SPID negotiation. So that both the device and
the PBX can ignore the SPID negotiation and initialization.
Execute this command only if no call exists on a BRI.
You cannot execute this command during the SPID negotiation on a BRI.
Examples
# Set the SPID processing mode to NIT on interface BRI 2/0.
<Sysname> system-view
[Sysname] interface bri 2/0
[Sysname-Bri2/0] isdn spid nit
Related commands
display isdn spid

isdn spid resend

Use isdn spid resend to set the number of INFORMATION message retransmission attempts for SPID
negotiation or initialization on a BRI that runs the NI protocol.
Use undo isdn spid resend to restore the default.
Syntax
isdn spid resend times
undo isdn spid resend
Default
The number of INFORMATION message retransmission attempts is 1.
Views
ISDN BRI interface view
Predefined user roles
network-admin
94