[Sysname-Serial2/0] remote address 10.0.0.1
# Configure Serial 2/0 to assign an IP address from the address pool aaa to the client.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] remote address pool aaa
Related commands
ip address ppp-negotiate
•
ip pool
•
timer-hold
Use timer-hold to set the interval for sending keepalive packets.
Use undo timer-hold to restore the default.
Syntax
timer-hold seconds
undo timer-hold
Default
The interval for sending keepalive packets is 10 seconds.
Views
Interface view
Predefined user roles
network-admin
Parameters
seconds: Interval (in seconds) for sending keepalive packets, in the range of 0 to 32767. The value 0
disables keepalive packet sending.
Usage guidelines
Because a slow link takes a long period of time to transmit large packets, the sending and receiving of
keepalives might be delayed so long that one end cannot receive keepalive packets from the peer for 10
keepalive periods and shuts down the link. To prevent this, set the interval for sending keepalive packets
to a relatively longer length of time for a slow link.
Examples
# Set the interval for sending keepalive packets to 20 seconds on interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] timer-hold 20
MP commands
bandwidth
Use bandwidth to configure the expected bandwidth of an interface.
12