Examples
# Configure an address pool aaa that contains IP addresses 129.102.0.1 through 129.102.0.10 for the
group a.
<Sysname> system-view
[Sysname] ip pool aaa 129.102.0.1 129.102.0.10 group a
Related commands
display ip pool
link-protocol ppp
Use link-protocol ppp to enable PPP encapsulation on an interface.
Syntax
link-protocol ppp
Default
PPP encapsulation is enabled on all interfaces except Ethernet and VLAN interfaces.
Views
Interface view
Predefined user roles
network-admin
Examples
# Enable PPP encapsulation on Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] link-protocol ppp
ppp authentication-mode
Use ppp authentication-mode to configure the PPP authentication mode.
Use undo ppp authentication-mode to disable PPP authentication.
Syntax
ppp authentication-mode { chap | pap } * [ [ call-in ] domain isp-name ]
undo ppp authentication-mode
Default
PPP authentication is disabled.
Views
Interface view
Predefined user roles
network-admin
Parameters
chap: Uses CHAP authentication.
4