H3C MSR Series Command Reference Manual page 27

display interface
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
interface-number: Specifies an existing VT interface by its number.
brief: Displays brief interface information. If you do not specify this keyword, this command displays
detailed interface information.
down: Displays information about interfaces in physically down state and the causes. If you do not
specify this keyword, this command displays information about interfaces in all states.
description: Displays complete interface description. Without this keyword, this command displays only
the first 27 characters of the interface description if the description has more than 27 characters.
Usage guidelines
If you do not specify the virtual-template keyword, this command displays information about all
interfaces on the device.
If you specify the virtual-template keyword without the interface-number argument, this command
displays information about all existing VT interfaces.
Examples
# Display detailed information about interface Virtual-Template 1.
<Sysname> display interface virtual-template 1
Virtual-Template1
Current state: DOWN
Line protocol state: DOWN
Description: Virtual-Template1 Interface
Bandwidth: 100000kbps
Maximum Transmit Unit: 1500
Hold timer: 10 seconds
Internet protocol processing: disabled
Link layer protocol: PPP
LCP: initial
Physical: None, baudrate: 100000000 bps
Output queue - Urgent queuing: Size/Length/Discards 0/100/0
Output queue - Protocol queuing: Size/Length/Discards 0/500/0
Output queue - FIFO queuing: Size/Length/Discards 0/75/0
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 0 packets, 0 bytes, 0 drops
# Display brief information about Virtual-Template 1.
Brief information on interface(s) under route mode:
virtual-template interface-number
[ [
brief description
] ] [ [
18
] ]