Replacing The Display On The 22" Touch Screen; Figure 86 Inside Of Door Showing Position Of The Four #6-32 Nuts - Mircom TX3 Series Installation Manual

3.17

Replacing the Display on the 22" Touch Screen

The 22" Touch Screen incorporates a 3M™ Multi-Touch Display
C2167PW (ID: 98000342422). If you need to replace it, follow these
instructions.
To remove the old display
1.
2.
3.
4.
TX3 Touch Screen Installation Manual
Shut down the 22" Touch Screen and disconnect the power.
Open the 22" Touch Screen door.
Unplug the power, USB and DVI cables.
The display is attached to two brackets (CH-1165), which are secured to
four posts on the door.
Remove the four #6 nuts and keep them.
Figure 86. Inside of door showing position of the four #6-32 nuts
Touch Screen System and Setup
99