Adding A Controller - Mircom TX3 Series Installation Manual

5.1

Adding a Controller

The TX3 Touch Screen may be integrated with other controllers, such as the
Telephone and Card Access systems, through a peer-to-peer connection via the
RS-485 bus.
Touch has a provision to add the TX3 Card Access controller inside the unit.
Note:
To integrate another controller
1.
2.
3.
4.
5.
6.
144 TX3 Touch Screen Installation Manual
Ensure that all network devices each have unique ID addresses.
Ensure the Touch Screen and the controller are setup and ready for
operation.
Turn the power OFF for Touch Screen and controller.
Connect the controller to the Touch Screen via the RS-485 bus using the
RS-485 connectors.
Turn the power ON for the Touch Screen and controller.
Connect the PC to either the Touch Screen or controller using the USB
port.
Use the TX3 Configurator Program to add and configure the controller to
the network.
Adding Controllers