Mircom TX3 Series Installation Manual page 34

2.5.2 Installing TX3-TOUCH-F22(-C/D)
Warning:
The flush mount enclosure mounts directly inside the wall to the wall stud or
supporting structure. Mount the enclosure flush with the wall and right-side up
(the Mircom logo on the door is on the bottom).
You need:
6 fasteners appropriate for the wall that you are mounting the enclosure on.
To mount the enclosure
1.
2.
3.
4.
34 TX3 Touch Screen Installation Manual
To prevent overheating, do not install any of the TX3 Touch
Screens in direct sunlight.
Find a suitable location for the flush mount enclosure beside a wall stud.
You can mount the enclosure using the keyholes on the back, or the
knockouts on the side, or both. The wall must be able to support a weight
of 80 lbs (37 kg).
Using the enclosure as a template, trace an opening in the wall for the cut
out with one side aligned with the side of the wall stud.
Cut an opening in the wall 0.1 inch larger than the trace ensuring that one
side is aligned with the wall stud or supporting structure.
Insert the enclosure into the wall cutout and using the side of the enclosure
as a template mark the hole mounting locations (either keyholes or
knockouts or both).
Installation