Before You Begin - Nortel 1000E Installation And Configuration Manual

Page 366 of 488

Before you begin

553-3041-210 Standard 4.00
Configuring an IP telephony node
The preconfigured IP telephony configuration files from the leader Signaling
Server must be imported. These files are saved on the CS 1000E as:
• c:/u/db/node/nodex.cfg where x is the node number
• c:/u/db/node/nodex.btp where x is the node number
Do not attempt to alter the configuration files either manually or with
OTM's ITG or IP Phone management. Use Element Manager only.
This chapter contains the following procedures:
• Procedure 92: "Turning off browser caching in Internet Explorer"
on page 367
• Procedure 93: "Logging in to Element Manager" on
• Procedure 94: "Importing an existing node" on
• Procedure 95: "Reviewing and submitting IP telephony node
configuration" on
• Procedure 96: "Adding a Follower Signaling Server to the IP telephony
node in Element Manager" on
• Procedure 97: "Performing a datadump using Element Manager"
on page 380
Perform a datadump
Use Element Manager to perform a datadump before making any changes to
the IP telephony node. A datadump backs up both the IP telephony node
configuration files and the customer database files. The datadump procedure
using Element Manager is outlined in Procedure 97 on
Enable the multi-user option
Enable the multi-user option to access Command Line Interface (CLI)
overlays and Element Manager at the same time. For more information about
September 2007
IMPORTANT!
page 374
page 379
page 370
page 372
page 380.