Hardware Requirements; Contents; Dass2 Hardware Requirements - Nortel Communication Server 1000 Manual

.

Hardware requirements

Contents

This section contains information on the following topics:
"DASS2 hardware requirements" (page 35)

DASS2 hardware requirements

The following hardware is required for each DASS2 link on CS 1000 and
Meridian 1systems.
•
one NTAG54 Dual Daughterboard (for NTCK43AB or higher vintages
of the Dual PRI)
or
•
one NT5K35 D-channel Handler Interface
or
•
one NT5K75 D-channel Handler Interface - an enhanced version of the
NT5K35 which provides up to 160 D-channel port addresses. This card
supports two switch-selectable modes of operation — standard mode
and expanded mode. Standard mode D-channels may be assigned
an input/output port address in the range 0-15; expanded mode
D-channels may be assigned port addresses in the range 0-159. Each
port has a set of DIP switches allowing full configuration flexibility. See
the section entitled
modes" (page 37)
or
•
one NT6D11AE/AF D-channel Handler Interface - an enhanced version
of the NT5K75 which is fully backward compatible with the NT5K75
and NT5K35. This card supports two switch-selectable modes of
operation — standard mode and expanded mode. Standard mode
D-channels may be assigned an input/output port address in the range
0-15; expanded mode D-channels may be assigned port addresses
in the range 0-159. Each port has a set of DIP switches allowing full
configuration flexibility. See the section entitled
pertaining to port addressing modes" (page 37)
"Engineering note pertaining to port addressing
in this chapter.
Nortel Communication Server 1000
DASS2 Fundamentals
NN43001-571 04.01 4 June 2010
Copyright © 2007-2010 Nortel Networks. All Rights Reserved.
"Engineering note
in this chapter.
35