7
Load the plate or the tube assembly
92
■
Load the plate or the tube assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 92
■
■
Lock the touchscreen . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 95
■
■
■
■
In the home screen:
1. Touch
, touch
2. Press the release button on the autosampler to open the lid.
3. Check the buffer fill level:
a. Remove the CBC.
b. Ensure that the level of buffer is
above the fill line.
If the buffer is at or below the fill
line, see "Assemble the
SeqStudio
Genetic Analyzer
™
Cathode Buffer Container (CBC)
" on page 166 and "Insert the
Cathode Buffer Container" on
page 167.
If the buffer is above the fill line,
reinsert the CBC.
4. Place the plate or tube assembly firmly
in the autosampler.
Start and monitor a run
Eject plate, then open the instrument door when prompted.
SeqStudio
Genetic Analyzer Instrument and Software User Guide
™
1
Replace if buffer is at or below the fill
line
1
New CBC buffer level
1
1