Set Up A Default Network Location For Saving Results (Auto Export) - Thermo Scientific Applied Biosystems SeqStudio Genetic Analyzer User Manual

10
Chapter 10 Manage the software (instrument)
Connect the instrument to a network drive
Set up a default
network location
for saving results
(auto export)
134
The Setup Run screen is displayed.
Figure 17 Setup Run screen example
Example IP address and folder locations
1
List of plates (will be blank if you have not saved plates to this location)
2
1. Determine the IP address of the computer on which you created shared folders
(see "Determine IP address for a computer on a network" on page 130 and
"Create folders and enable network folder sharing" on page 131 ).
2. In the home screen of the instrument, touch Setup run, then touch Create new
plate setup.
3. Touch Save location.
4. Touch the network Destination field.
If your instrument
profile
Is not connected to a
network drive
Is connected to a
network drive
This screen is
displayed
Connect
Select Directory
SeqStudio Genetic Analyzer Instrument and Software User Guide
™
1
2
How to proceed
1. In the Network Destination
field, enter the IP address of
the computer followed by the
folder names you created.
Example:
10.43.32.82/SharedData/Resu
lts.
2. If required by your network,
enter Domain, User Name,
and Password to access the
shared location.
3. Touch Connect. The Select
Directory screen is displayed.
Proceed to step 5.