Machine-Specific Configuration - Raven SmarTrax Calibration And Operation Manual

• Load allows the operator to select an existing profile. Load will not be displayed as an option until a
machine calibration has been performed and a new profile has been set up.
◦
If the profile chosen has previously been calibrated on the machine, the calibration process is
complete.
◦
If the profile chosen has not been calibrated on the machine, the calibration process must be
completed as outlined in the following sections in this manual.
• Reset clears the previous profile settings. Once Reset is selected, the operator must select the machine
from the Machine Type list and the calibration process must be completed as outlined in the following
sections in this manual. Reset will not be displayed as an option until a machine calibration has been
performed and a new profile has been set up.
4. Select Next.

MACHINE-SPECIFIC CONFIGURATION

NOTE: It may be necessary to configure the GPS com port in the field computer to allow GPS
communication with the SmarTrax. Refer to the Viper/Viper 4+ Installation and Operation Manual
(P/N 016-0171-539) for information on com port configuration and additional machine measurements
(such as guidance width) that must be entered into the field computer.
Before the SmarTrax system may be enabled, the SmarTrax system must be calibrated for the specific vehicle
being used. Complete the following steps to configure the machine specifications in the Viper 4 and the SmarTrax
system.
FIGURE 9. Vehicle Selection Screen
1. Select the specific machine type from the Machine Type list. If the specific machine is not listed, choose the
generic machine type that best fits the machine:
• SP Sprayer RBoom - Self-propelled sprayer with a rear boom
• SP Sprayer FBoom - Self-propelled sprayer with a front boom
• FS Tractor - Front-steered tractor
• Articulated
• Rear Steered - Rear-steered machine
2. Select Next.
P/N 016-0171-277 Rev. L
VIPER 4/4+ CALIBRATION AND OPERATION
45