3D Compensation Calibration - Raven SmarTrax Calibration And Operation Manual

antenna is located 3 feet behind the rear axle, the value would be entered as -3. Raven Industries
recommends mounting the antenna in front or even with the rear axle.
NOTE: If the Antenna Position value is edited, the system will automatically advance to the next stage of the
calibration process. If the value is not edited, the operator must select
FIGURE 16. Antenna Height Configuration Screen
5. To figure the Antenna Height, measure the distance from the ground to the middle of the GPS antenna.
6. Select the value box to enter the Antenna Height measurement using the on-screen keypad.
NOTE: If the Antenna Height value is edited, the system will automatically advance to the next stage of the
calibration process. If the value is not edited, the operator must select

3D COMPENSATION CALIBRATION

NOTE: The calibration may take a few minutes to complete.
1. Drive the machine forward 33 feet and park on a flat surface.
NOTE: The machine must detect a forward motion prior to calibration to determine which direction is
forward.
2. Follow the on-screen instructions to begin the calibration.
FIGURE 17. Machine's Rear Axle Marked Before Enhanced Tilt Calibration
3. Place flags or markers on the outside of each rear wheel aligned with the axle.
P/N 016-0171-277 Rev. L
CR7 CALIBRATION AND OPERATION
Next to continue.
Next to continue.
23