Connect The Harness To The Machine - Raven AccuBoom Installation Manual

Connect the Harness to the Machine

SpraCoupe Boom Control Node
FIGURE 3.
Locate the CAN node bank on the right-rear corner of the machine's center rack.
1.
Locate the black connector on the machine's boom control node containing the blue boom control wires.
2.
Disconnect the black connector from the machine's boom control node.
3.
Connect the black node connector to the receiving end on the AccuBoom harness cable (P/N 115-1001-
4.
040).
Connect the node connector on the AccuBoom harness cable to the open port of the machine's boom
5.
control node.
Note:
The 3-pin Deutsch connectors on the AccuBoom harness cable should remain connected
together. They are not needed for the 5-section machine configuration and are used only as a
European option.
Manual No. 016-1001-077
AccuBoom Installation
9