Chapter 5 Completing Hawkeye Ready Machine Installation; Boom Cable Connections; Electrical Connection - Raven Hawkeye Installation Manual

CHAPTER
5
If the machine is Hawkeye ready, complete the steps in this chapter to complete the installation. If the machine is
not Hawkeye ready, skip to "Cab Preparation and Wiring" on page 25. Hawkeye ready is a factory option for 2017+
model years. These Hawkeye ready units came with a Viper 4 field computer and ISO Product Controller II.

BOOM CABLE CONNECTIONS

Connect the primary Hawkeye boom cables installed in the "Boom Cable Routing and Connection" section on
page 18 to the boom cable connections. These are located on the center rack, just below the section control
valves.
FIGURE 1. Boom Cable Connections
Boom Cable Connections

ELECTRICAL CONNECTION

1. Connect the round power plug on the power cable (P/N 115-7303-144) to the receptacle on the OEM harness
located on the center rack beneath the electrical box.
Manual No. 016-0171-587 Rev. C
C OMPLETING HAWKEYE READY
C H A P T E R 5
MACHINE INSTALLATION
23