Chapter 6 Envizio Pro And Cruizer Ii Calibration And Operation; Introduction; Software Compatibility; Smartrax Status Display - Raven SmarTrax Calibration And Operation Manual

CHAPTER
6

INTRODUCTION

SOFTWARE COMPATIBILITY

The instructions in this manual apply to Envizio Pro field computers with software version 3.6 or higher and
Cruizer II field computers with software version 3.1.2.29627 or higher. The SmarTrax node must be running
software version 6.0 or higher. If the field computer or node is running with an older version of software, refer to
the Installation & Operation Manual included with the field computer for instructions on updating software
versions.

SMARTRAX STATUS DISPLAY

FIGURE 1. Main Menu
NOTE: The images contained in this chapter are taken from the Envizio Pro display. If a Cruizer II is being
used, the images may vary slightly from the those referenced in this chapter.
P/N 016-0171-277 Rev. L
E NVIZIO PRO AND CRUIZER II
C H A P T E R 6
CALIBRATION AND OPERATION
Start
Tools
Exit Button
101