Check The Machine's Flow Switch Configuration - Raven SmarTrax Installation Manual

DGPS OUT Connected to Console Receiver Connection
FIGURE 8.
Console
Cable
Route and connect the DGPS OUT connector to the console's DGPS connector.
4.
Connect the CASE GPS connection and the DGPS IN connection from the node harness cable together.
5.
Loop and tie-off the ENABLE cable connection, securing it with plastic cable ties as necessary.
6.
Note:
The ENABLE connector is not used in the SmarTrax system. Ensure the cable is secured away
from moving parts and heat sources.
Check the Machine's Flow Switch
Configuration
Note:
A change to the flow switch in Case IH Patriot Steering-Ready machines causes the disengage
signal to not change state. Complete the following steps to ensure the disengage signal is fully
functional.
Flow Switch Configuration
FIGURE 9.
Manual No. 016-5032-085 Rev. B
New Flow Switch
(Cable Out Bottom)
Cab Component Installation
Old Flow Switch
(Cable Out Top)
Console
Receiver
DGPS
Connection
DGPS OUT
(Node
Harness
Connection)
11