Calibrate The Smartrax System; System Disengage Calibration - Smartrax Only; Smartrax Systems With A Pressure Transducer Installed - Raven SmarTrax Calibration And Operation Manual

CALIBRATE THE SMARTRAX SYSTEM

SYSTEM DISENGAGE CALIBRATION - SMARTRAX ONLY

SMARTRAX SYSTEMS WITH A PRESSURE TRANSDUCER INSTALLED

IMPORTANT: This section applies only to SmarTrax systems utilizing a pressure transducer to disengage the SmarTrax
system when the steering wheel is turned. If a flow or pressure switch is installed in the SmarTrax system,
refer to the SmarTrax Systems with a Flow Switch or Pressure Switch Installed section on page 110 to
calibrate the SmarTrax system.
FIGURE 13. Transducer Calibration Screen
1. Press Start. The following screen will appear:
FIGURE 14. Transducer Calibrating Screen
2. When prompted, turn the steering wheel to allow the SmarTrax system to detect the hydraulic pressure
change. Once the system has detected the static and differential pressures, the following screen will be
displayed:
P/N 016-0171-277 Rev. L
ENVIZIO PRO AND CRUIZER II CALIBRATION AND OPERATION
109