Xerox 8850 Service Manual page 106

5. (Figure 2): Remove the Fuser Drive Gear from the Printer.
1
Remove the grip ring from the Fuser
Drive Shaft
2
Slide the Fuser Drive Gear off
the Drive Shaft
Figure 2 Removing the Fuser Drive Gear from the Printer
6. (Figure 3): Remove the following connectors and ground strap from the left of the Media
Transport Module (view from paper feed side of Printer).
Repairs and Adjustments
REP 8.2
5
Disconnect P/J A21P1
3
Disconnect the
ground strap
Figure 3 Disconnecting the Connectors
03/2003
4-30
4
Disconnect the two wire connectors
2 1
Remove the Bias Remove the
Transfer Roll to pre- Media Guides
vent it from falling out
and damaging the roll
8850/ 510DP