Rep 8.3 Sheet Feed Sensor - Xerox 8850 Service Manual

5. (Figure 6): Secure the Shaft Release Pin, locking the Media Transport Module in position.
1
Ensure that the lock washer is touch-
ing the side wall of the Printer
Figure 6 Locking the Media Transport Module in Position
6. Reinstall the plastic Developer Baffle (if removed).
7. Reinstall the Developer Module (if removed).
8. Reinstall the Lower Sheet Feed Assembly.
9. Return the Printer to normal operation.
Repairs and Adjustments
REP 8.2, REP 8.3
2
Rotate the retaining
bracket upward, and
tighten the screw

REP 8.3 Sheet Feed Sensor

Parts List on PL 10.7
Switch off the Main Power Switch. Disconnect the Power Cord.
Removal
1. Remove the Lower Sheet Feed Assembly from the Printer. Perform
2. (Figure 1): Remove the Vacuum Baffles from the Lower Sheet Feed Assembly.
1
Slide the baffles downward and out of the
Lower Sheet Feed Assembly
Figure 1 Removing the Vacuum Baffles
3. Turn the Lower Sheet Feed Assembly over.
03/2003
4-32
WARNING
REP 8.1.
8850/ 510DP