4.
(Figure 3): Remove the Edge (RT 2) or (RT 3) Thermistor.
Edge Thermistor
(RT 2)
Figure 3 Removing the Edge or Center Thermistor
8850/ 510DP
Center Thermistor
(RT 3)
1
Remove the screw, disconnect the con-
nector and remove the Thermistor
REP 10.8 Pressure Roll
Parts List on
PL 10.4
Removal
NOTE: In
following procedure the terms "left" and "right" describe machine locations as
observed from the Roll Media Supply Drawer side of the Printer.
1.
(Figure 1): Access the Fuser.
1
Pull up on the handle and pull open the
Fuser Module Drawer.
Figure 1 Accessing the Fuser
03/2003
4-129
Repairs and Adjustments
REP 10.7, REP 10.8