9.
(Figure 8): Carefully remove the Drum Assembly from the Printer and place it, Gear Box
down, in a safe area in the room.
Temporary placement of the Drum Assembly as
shown will prevent the Drum from coming in
contact with contaminated surfaces
Figure 8 Temporary Placement of the Drum Assembly
8850/ 510DP
REP 9.3 Drum
Parts List on
Drum Assembly
Switch off the Main Power Switch. Disconnect the Power Cord.
Removal
NOTE: When the Drum is replaced, install a Cleaner Blade Kit
1.
Remove the Drum Assembly
2.
(Figure 1): Carefully place the Drum Assembly, Gear Box down, in a safe place on the
floor.
Gear Box
03/2003
4-61
PL 9.2
WARNING
(REP
9.2).
Drum Assembly
Gear Box
Figure 1 Temporary Placement of the Drum Assembly
(REP
9.4).
Repairs and Adjustments
REP 9.2, REP 9.3