Xerox 8850 Service Manual page 163

4. (Figure 3): Reinstall the Top Shield, taking care not to overtighten the screws.
In the following step take care not to overtighten the two screws on the interior side of the
Developer Module, as this can cause the screws to puncture the Top Shield.
4
Connect M1
2
Reinstall the
screws (2)
Figure 3 Reinstalling the Top shield
5. Reinstall the Developer Module (REP
8850/ 510DP
CAUTION
3
Tighten the screws
(2), being careful not
to drive the screws
through the Top
Shield
1
Reinstall the Top Shield
9.5).
03/2003
4-87
Repairs and Adjustments
REP 9.12