Xerox 8850 Service Manual page 127

2. (Figure 7): Reinstall the Fuser Exit Sensor.
2
Guide Exit Roll Shaft into
frame of Shaft Support
3
Install Catch Tray
Block as shown
Catch Tray Block
Figure 7 Reinstalling the Fuser Exit Sensor (Cutaway view from Printer Right Side)
3. Reconnect P/J Q1P1 to the Fuser Exit Sensor.
4. Reinstall the plastic bearing and E-ring on the left side of the Printer Exit Roll.
5. (Figure 8): Reinstall the Printer right side hardware.
8850/ 510DP
1
Place Exit Sensor lever up
through cutout in Vacuum
Transport Platform
Exit Roll Shaft Sup-
port
Vacuum Transport
Platform
1
Reinstall plastic bearing and E-
ring
2
Reinstall Exit Roll Drive Gear with
small plastic nib on gear placed up
against flat area on Exit Roll Drive
Shaft
Figure 8 Reinstalling the Printer Right Side Hardware
6. Reinstall the Upper Sheet Feed Housing.
7. Swing closed the Fuser Module Front Cover.
8. Close the Fuser Module Drawer.
9. Return the Printer to normal operation.
03/2003
4-51
4
Reinstall E-ring on Exit Roll Drive
Gear
3
Reinstall drive belt by placing it on
Exit Roll Drive Gear and working it
onto neighboring gear
Repairs and Adjustments
REP 8.16