Rep 8.2 Media Transport Module - Xerox 8850 Service Manual

REP 8.2 Media Transport Module

Parts List on PL 8.1
Switch off the Printer Power Switch. Disconnect the Printer Power Cord.
NOTE: In the following steps, the terms "Left" and "Right" describe machine locations as
observed when facing the Printer from the Roll Media Supply Drawer side.
1. Ensure that the Fuser Drawer is opened.
2. Remove the Lower Sheet Feed Assembly. Perform
bly.
NOTE: Technical Representatives may find it helpful to remove the Developer Module
prior to attempting the removal of the Media Transport Module, as it allows better visibility.
Removing the Developer Assembly and its Plastic Baffle is therefore optional for the com-
pletion of this procedure.
NOTE: Opening the Cutter Drawer will also make removing the Media Transport Module
easier.
3. (Optional) Remove the Developer Module. Perform
4. (Figure 1): Open the Printer Front Cover (beneath the Control Panel) and release the
spring tension on the Shaft Release Pin.
8850/ 510DP
WARNING
REP 8.1 Lower Sheet Feed Assem-
REP 9.5 Developer Module.
1
Loosen the phillips screw slightly and
rotate the bracket downward
Figure 1 Releasing the Tension on the Shaft Release Pin
03/2003
4-29
2
Pull the Shaft Release Pin outward
Repairs and Adjustments
REP 8.2