Xerox 8850 Service Manual page 201

NOTE: If the frame screws had to be loosened to remove the rolls, tighten the four
screws.
NOTE: Step 1: Install the Web Oiler so that the web is coming off the bottom of the Sup-
ply Roll as shown with the Web Oil Assembly laying up-side-down.
3
Push the Rolls to the left and
insert them in the frame
1
Install the Web Oiler as shown in this diagram
Sup-
ply
Figure 4 Reinstalling the Web Oiler
8850/ 510DP
2
Install the Take Up Roll with
the slot on the right side (drive
side)
Take up
Pinch
Roll Roll
Ensure that there are no wrinkles in the Web when tensioning the web in the following
procedure. Wrinkles can cause print quality problems.
2. (Figure 5): Reinstall the Takeup Roll Gear.
2
Carefully remove any excess play in
the Web by rotating the gear in the
direction shown
Figure 5 Reinstalling the Gear
03/2003
4-125
CAUTION
1
Install the gear with the
raised hub towards the frame
Repairs and Adjustments
REP 10.5