Rep 8.14 Cutter Home Sensor - Xerox 8850 Service Manual

REP 8.14 Cutter Home Sensor

Parts List on PL 7.8
Switch off the Main Power Switch. Disconnect the Power Cord.
Removal
1. Open the Cutter Drawer.
2. (Figure 1): Remove the Cutter Home Sensor.
1
Disengage the two mount stubs
4
Disconnect Q1P1
Figure 1 Removing the Cutter Home Sensor
8850/ 510DP
WARNING
2
Rotate the sensor downward and
remove it from the mount bracket
3
Remove the wire from
the mount clip
Replacement
1. Center the disc of the Cutter Drive Pulley in the Cutter Home Sensor during reinstallation
of that sensor.
03/2003
4-45
Repairs and Adjustments
REP 8.14