Rep 8.18 Detack Corotron/Btr Extrusion - Xerox 8850 Service Manual

REP 8.18 Detack Corotron/BTR Extrusion

Parts List on PL 8.3
Switch off the Main Power Switch. Disconnect the Power Cord.
Removal
NOTE: In the following steps, the terms "Left" and "Right" describe machine locations as
observed when facing the Printer from the Roll Media Supply Drawer side of the Printer.
1. Remove the Media Transport Module
2. Remove the Bias Transfer Roll (REP
3. Remove the Detack Corotron (REP
4. (Figure 1): Remove the two screws from the Left Side End Plate.
Figure 1 . Removing the Left Side Screws
5. (Figure 2): Remove the Fthe two screws from the Right Side End Plate.
8850/ 510DP
WARNING
(REP 8.2).
9.22).
9.9).
1
Remove the 2 Screws
Figure 2 . Removing the Right Side Screws
03/2003
4-55
1
Remove the 2
Screws
Repairs and Adjustments
REP 8.18