8850 Change Tag Information - Xerox 8850 Service Manual

8850 Change Tag Information

Introduction
The purpose of this section is to list the Change Tag Index.
All important modifications are identified by a Tag number on a matrix card attached to the
machine.
This section describes all of the Tags as well as multinational applicability, classification codes,
and permanent or temporary modification information.
Classification Codes
A Tag number may be required to identify differences between parts that cannot be inter-
changed, or differences in diagnostic, repair, installation, or adjustment procedures. A Tag
number may also be required to identify the presence of optional hardware, special non-vola-
tile memory programming, or if mandatory modifications have been installed.
Each Tag number is given a classification code to identify the type of change the Tag has
made:
M - Mandatory
N - Not installed in the field
O - Optional
R - Repair
TAG: Not Used
CLASS: S
USE:
MFG SERIAL NUMBERS:
NAME:
PURPOSE:
KIT NUMBER:
REFERENCE:
TAG: 2
CLASS: O
USE: All
MFG SERIAL NUMBERS:
NAME: Developer Heater
PURPOSE: To control the temperature of the developer material to prevent a low tribo con-
dition (Sleep Mode) in high humidity conditions.
KIT NUMBER: 605K11690
REFERENCE: N/A
8850/ 510DP
TAG: 3
CLASS: N/A
USE:
MFG SERIAL NUMBERS:
NAME:
PURPOSE: .
KIT NUMBER:
REFERENCE: N/A
TAG: 4
CLASS: R
USE: All
MFG SERIAL NUMBERS:
NAME: Media Corner Curl
PURPOSE: To provide two guides to be installed on the Stripper Finger Assembly to elimi-
nate damage to the lead edge corners of large media.
KIT NUMBER: 604K12770
REFERENCE: N/A
TAG: 5
CLASS: R
USE: All
MFG SERIAL NUMBERS:
NAME: Fuser Wire Insulation
PURPOSE: To provide a new fuser lamp harness with better insulation properties to with
stand the fuser heat.
KIT NUMBER: 604K12880
REFERENCE: N/A
03/2003
8850 Change Tag Information, SPS 510dp Change
6-47
General Procedures