Rep 9.25 Ozone Filter (Sps 510Dp) - Xerox 8850 Service Manual

REP 9.25 Ozone Filter (SPS 510dp)

Parts List on PL 9.9
Removal
1. Switch off the Printer.
2. Open the Rear Cover and raise the Top Cover.
3. (Figure 1): Remove the Rear Top Cap.
2
Lift and hold the
Developer Cover open
and remove the Top
Cap
1
Remove the four
screws, two top and
bottom
Figure 1 Removing the Top Rear Cap
4. (Figure 2): Remove the ozone filter.
Replacement
1. (Figure 3): Install the Ozone Filter
8850/ 510DP
3
Remove the screw
securing the Ozone
Filter
03/2003
4-109
2
Reinstall the Screw
Figure 2 Installing the Ozone Filter
Bottom sur-
face of Filter
flush with
edge of
sheet metal
1
Place the Filter in the Cover
at an angle from the screw
to the top edge of the sheet
metal. The bottom surface
of the Filter should be flush
with the edge of the sheet
metal
Repairs and Adjustments
REP 9.25