Xerox 8850 Service Manual page 316

23. (Figure 17): Prepare to level the Printer. Rotate the leveling bolts (located inside the front
and rear doors) fully counterclockwise.
Rotate bolts fully counterclockwise
Figure 17 Preparing to level the Printer
General Procedures
Installation Procedure
24. (Figure 18): Check the front-to-rear level of the Printer.
1
Place the level
on the metal
edge of the
developer
module and
check the
front-to-rear
level of the
Printer.
Figure 18 Checking the level of Printer
NOTE: To ensure that the Printer frame is not twisted, use a level on both end frames to per-
form the side-to-side level check.
NOTE: Adjust the end that is farthest out of level first.
03/2003
6-30
2
Check the side-to-side level
at the base of the Printer.
3
Repeat the side-to-side
level check at the other
end of the Printer.
8850/ 510DP