Xerox 8850 Service Manual page 176

14. (Figure 8): Disconnect the Ground Wire and release the harness from the cable clamps.
1
Remove the screw to
disconnect the Ground
Wire
Figure 8 Preparing the Harness for Removal
NOTE: Observe the way that the spring rests on the frame, underneath the cable clamp. This
is how the reassembled parts must fit.
15. (Figure 9): Complete the removal preparation on the front area of the Image Module
Assembly.
Repairs and Adjustments
REP 9.20
2
Release the harness from the
cable clamps
2
Remove the screw
and the cable clamp
Spring
1
Remove the
bolt from the
end of the
shaft
Top Cover
Support
Bracket
Figure 9 Preparing to Remove the Image Module Assembly (View looking at the Front
03/2003
4-100
3
Pull the harness up to
the level of the Image
Module
4
Remove the two
E-rings
from the Right Side)
8850/ 510DP