REP 10.1 Heat Rods, Edge (HR 1) and Center (HR 2)
Parts List on
PL 10.2
Switch off the Main Power Switch. Disconnect the Power Cord. Allow the Fuser Assem-
bly to cool before the procedure is performed.
Removal
1.
(Figure 1): Access the Fuser Module.
1
Pull up on the handle and pull open
the Fuser Module Drawer
Figure 1 Accessing the Fuser Module
8850/ 510DP
WARNING
NOTE: In the following steps, the terms "Left" and "Right" describe machine locations as
observed from the Roll Media Supply Drawer side of the Printer.
2.
(Figure 2): Disconnect the Heat Rod and remove the bracket (Left side).
2
Remove the Heat Rod Sup-
port Bracket (2 screws)
3
Remove the rubber grommet from
the Heat Rod Support Bracket
Figure 2 Removing the Bracket (Left side)
03/2003
4-111
1
Disconnect the two Heat Rod
Connectors
4
Carefully remove the two Heat Rods
from the rubber grommet
Repairs and Adjustments
REP 10.1