Rep 10.7 Edge And Center Thermistors (Rt 2) And (Rt 3) - Xerox 8850 Service Manual

REP 10.7 Edge and Center Thermistors (RT 2) and (RT 3)

Parts List on PL 10.3
Removal
1. (Figure 1): Access the Fuser Module.
1
Pull up on the handle and pull open the
Fuser Module Drawer.
Figure 1 Accessing the Fuser Module
2. Remove the Fuser Heat Roll (REP
3. (Figure 2): Access the Edge (RT 2) or Center (RT3) Thermistor.
Repairs and Adjustments
REP 10.7
10.2)
1
Remove the two screws,
one each side and remove
the Cover
Figure 2 Accessing the Edge and Center Thermistors
03/2003
4-128 8850/ 510DP