Xerox 8850 Service Manual page 312

1
Raise the raise
the Image Mod-
ule
Figure 9 Removing the shipping pads
7. Slide the Fuser Assembly back into the Printer.
8. (Figure 10): Disengage the developer module shipping brackets.
General Procedures
Installation Procedure
2
Remove the shipping
pads, one from each
end of drum
3
Remove the
shipping
pads, one
from each
side under-
neath top
cover.
03/2003
6-26
1
Loosen screw
3
Retighten
screw
Figure 10 Disengaging the shipping brackets
9. Close the image module.
10. Open the Roll Media Supply Drawers and remove the packaging.
11. Hold the Top Cover open enough to enable the removal of the Rear Developer Cover.
Then close the Top Cover.
NOTE: Filling the developer module with developer without removing the developer module
from the Printer requires experience. If not experienced with the following procedure, go to
REP 9.5 to gain experience in removing and replacing the developer module components.
12. Lift open the developer module door, located on the top right side of the Printer.
13. Remove the toner cartridge from the developer module.
2
Slide bracket
off shaft
4
Repeat steps 1 through 3
at the other end of the
developer module
8850/ 510DP