3.
(Figure
3): Disconnect the Heat Rods and guide them into the Fuser Heat Roll (Right
Side).
2
1
Remove the two wires
Disconnect the two Heat
from the wire clamp
Rod connectors
Figure 3 Guiding the Heat Rods into the Fuser Heat Roll (Right Side)
Wear gloves or wrap a sheet of paper around the Heat Rod when handling the Heat Rod. Do
not touch the glass section of the Heat Rod. Oil from fingers can cause damage to the Heat
Rod.
Repairs and Adjustments
REP 10.1
3
Remove the Heat Rod Support
Bracket (2 screws)
4
Carefully remove the two Heat
Rods from the rubber grom-
met
CAUTION
4.
(Figure 4): Remove the Heat Rod(s).
NOTE: The heat rods can be removed from either side of the Fuser Module.
1
Remove the Heat Rod(s)
Figure 4 Removing the HeatRod(s)
03/2003
4-112
8850/ 510DP