Xerox 8850 Service Manual page 207

4. (Figure 4): Prepare to remove the Pressure Roll left side.
2
Remove the screw
Figure 4 Preparing to Remove the Pressure Roll
8850/ 510DP
1
Use the Spring Removal tool to remove
the Spring from the frame
3
Remove the E-ring from
the guide pin
5. (Figure 5): Remove the Pressure Roll from the Printer.
4
Remove the Pressure Roll from the underside
of the Fuser Assembly, right side first
Pressure Roll
Shaft
3
Lift the Pressure Roll slightly and guide
the inner shoulder of the shaft out the
circular cutout at the base of the slot
Figure 5 Removing the Pressure Roll from the Printer
6. (Figure 6): Remove the Pressure Roll from the Shaft.
03/2003
4-131
1
Lower the Latching Cover by releas-
ing the two latches located at either
side of the top of the cover
2
Remove the Guide Pin from the slot
and drop the Pressure Roll Support
Arm downward
Repairs and Adjustments
REP 10.8